CJXSL - INTERNATIONAL THINNER, GTA004

Product Identification

Product ID:INTERNATIONAL THINNER, GTA004
MSDS Date:05/19/1997
FSC:8010
NIIN:00N093302
Status Code:A
MSDS Number: CJXSL

Responsible Party
COURTAULDS COATINGS INC INTERNATIONAL
6001 ANTOINE DRIVE
HOUSTON, TX 77091
US

Emergency Phone: 800-854-6813

Info Phone: 713-684-1563; 908-964-2206

Cage: 0TZA3

Contractor
INTERNATIONAL PAINT INC
HOUSTON, TX 77091 US

Telephone: 713-684-1244; 908-964-2206

Cage: 0TZA3

Ingredients

STODDARD SOLVENT; (MINERAL SPIRITS)

CAS: 8052-41-3

RTECS: WJ8925000

OSHA PEL 2900 MG/M3;500 PPM

ACGIH TLV: 525 MG/M3;100 PPM

Hazards

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHALATION: CAUSES NOSE AND THROAT
IRRITATION. EYES: CAUSES EYE IRRITATION. SKIN: CAUSES SKIN
IRRITATION. INGESTION: CAN RESULT IN IRRITATION OF THE MOUTH,
STOMACH TISSUE AND DIGESTIVE TRACT.
Effects of Overexposure:SEE HEALTH HAZARDS.

First Aid

First Aid:GEN: IN ALL CASES OF DOUBT/WHEN SYMPTOMS PERSIST, SEEK
MEDICAL ATTENTION. NEVER GIVE ANTYHING BY MOUTH TO AN UNCONSCIOUS
PERSON. INHAL: REMOVE TO FRESH AIR. IF DISCOMFORT IS
PRESENT/BREATHING IS ABSEN T, GET MEDICAL ATTENTION IMMEDIATELY.
EYES: FLUSH IMMEDIATELY W/PLENTY OF WATER FOR AT LEAST 15 MINUTES,
UNTIL IRRITATION SUBSIDES. IF IRRITATION PERSISTS, GET MEDICAL
ATTENTION. SKIN: FLUSH W/LARGE A MOUNTS OF WATER. USE SOAP IF
AVAILABLE. REMOVE SEVERELY CONTAMINATED CLOTHING (INCLUDING SHOES)
& WASH BEFORE REUSE. IF IRRITATION PERSISTS, GET MEDICAL ATTENTION.
INGEST: DO NOT INDUCE VOMITING. KEEP AT REST. GET PROMPT MEDICAL
ATTENTION.

Fire Fighting

Flash Point:=37.8C, 100.F
Lower Limits:1%
Extinguishing Media:FOAM, CARBON DIOXIDE, DRY CHEMICAL.
Fire Fighting Procedures:WEAR NIOSH APPROVED SELF-CONTAINED BREATHING
APPARATUS AND FULL PROTECTIVE EQUIPMENT . IN THE ABSENCE OF
ELECTRICITY, A WATER SPRAY (A FOG NOZZLE IF PREFERRED) MAY BE USED
TO COOL CONTAINERS.
Unusual Fire/Explosion Hazard:ISOLATE FROM HEAT, SPARKS, ELECTRICAL
EQUIPMENT AND OPEN FLAME. CLOSED CONTAINERS MAY EXPLODE WHEN
EXPOSED TO EXTREME HEAT. DECOMPOSITION AND COMBUSTION PRODUCTS MAY
BE TOXIC. OSHA CLASSIFICATION: COM BUSTIBLE LIQUID - CLASS II.

Accidental Release

Spill Release Procedures:CONTAIN SPILLED LIQUID WITH SAND OR EARTH. DO
NOT USE COMBUSTIBLE MATERIALS SUCH AS SAWDUST. ABSORB SPILL WITH AN
INERT MATERIAL (E.G., DRY SAND OR EARTH), THEN PLACE IN A CHEMICAL
WASTE CONTAINER.

Handling

Handling and Storage Precautions:KEEP CONTAINER CLOSED. LOOSEN CLOSURE
CAUTIOUSLY BEFORE OPENING. STORE IN A COOL, WELL VENTILATED PLACE,
AWAY FROM INCOMPATIBLE MATERIALS. (SEE STABILITY AND REACTIVITY
SECTION.) KEEP AWAY FROM HEAT, SPARKS AND FLAMES. PROTECT MATERIAL
FROM DIRECT SUNLIGHT.
Other Precautions:GROUND AND BOND CONTAINERS WHEN TRANSFERRING
MATERIALS. EMPTY CONTAINERS MAY RETAIN HAZARDOUS PROPERTIES.
FOLLOW ALL MSDS/LABEL WARNINGS, EVEN AFTER THE CONTAINER IS
EMPTIED.

Exposure Controls

Respiratory Protection:USE A RESPIRATOR APPROVED BY NIOSH AND IN
ACCORDANCE WITH 29 CFR 1910.134 TO REMOVE PARTICULATES (AND VAPORS
IF THERE IS OVEREXPOSURE TO VAPORS GENERATED DURING THE PROCESSING
OF THIS PRODUCT).
Ventilation:PROVIDE SUFFICIENT VENTILATION, IN VOLUME AND PATTERN, TO:
A) KEEP THE TLV OF HAZARDOUS INGREDIENTS BELOW THE LIMITS SPECIFIED
IN INGREDIENS SECTION; (SUP DAT)
Protective Gloves:WEAR CHEMICAL RESISTANT GLOVES.
Eye Protection:ANSI APPROVED CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:ANSI APPROVED EMERGENCY EYEWASH AND DELUGE
SHOWER . AS NEEDED, USE BODY PROTECTION TO AVOID CONTACT WITH
PRODUCT.
Supplemental Safety and Health
VENTILATION: B) REMOVE VOLATILES PRODUCED DURING CURE AND DECOMPOSITION
PRODUCTS PRODUCED DURING WELDING OR CUTTING ON SURFACES COATED WITH
THIS PRODUCT.

Chemical Properties

Boiling Pt:=157.2C, 315.F
Vapor Density:HVR/AIR
Spec Gravity:0.77
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:LIQUID.

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Hazardous Decomposition Products:MAY PRODUCE HAZARDOUS FUMES WHEN
HEATED TO DECOMPOSITION AS IN WELDING. FUMES MAY PRODUCE CARBON
DIOXIDE AND CARBON MONOXIDE.

Disposal

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH LOCAL, STATE AND
FEDERAL REGULATIONS. DO NOT INCINERATE UNOPENED CONTAINERS.

Toxicology

Toxicological Information:THERE IS NO DATA AVAILABLE ON THE PRODUCT
ITSELF.

Other Information

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.

Ecology

Ecological:THERE IS NO DATA AVAILABLE ON THE PRODUCT ITSELF.

Transport

Transport Information:DOT (DEPARTMENT OF TRANSPORTATION): PROPER
SHIPPING NAME: PAINT RELATED MATERIAL; HAZARD CLASS: FLAMMABLE
LIQUID, 3; UN NUMBER: UN1263; PACKING GROUP: NOT REGULATED.

Regulatory

SARA Title III Information:NO REPORTABLE INGREDIENTS.
Federal Regulatory Information:TSCA (TOXIC SUBSTANCE CONTROL ACT):
COMPONENTS OF THIS PRODUCT ARE LISTED ON THE TSCA INVENTORY. CERCLA
(COMPREHENSIVE RESPONSE COMPENSATION, AND LIABILITY ACT):
MANUFACTURER RECOMMENDS YOU CONTACT LO CAL AUTHORITIES TO DETERMINE
IF THERE MAY BE OTHER LOCAL REPORTING REQUIREMENTS.
State Regulatory Information:CALIFORNIA PROPOSITION 65: NO REPORTABLE
INGREDIENTS.